Stp Show Commands; Show Spanning-Tree - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
5.1.16.1 no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format
Mode

5.2 STP Show Commands

This section describes the commands you use to view information about STP
configuration and status.

5.2.1 show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree,
when the optional parameter "brief" is not included in the command. The following details
are displayed.
Format
Modes
Bridge Priority
Bridge Identifier
Time Since
Topology
Change
Topology Change
Count
Topology
Change
Designated Root
Root Path Cost
5-10
no spanning-tree port mode all
Global Config
show spanning-tree <brief>
Privileged EXEC
User EXEC
Specifies the bridge priority for the Common and Internal
Spanning tree (CST). The value lies between 0 and 61440. It
is displayed in multiples of 4096.
The bridge identifier for the CST. It is made up using the
bridge priority and the base MAC address of the bridge.
Time in seconds.
Number of times changed.
Boolean value of the Topology Change parameter for the
switch indicating if a topology change is in progress on any
port assigned to the common and internal spanning tree.
The bridge identifier of the root bridge. It is made up from the
bridge priority and the base MAC address of the bridge.
Value of the Root Path Cost parameter for the common and
internal spanning tree.
v1.0, December 2005
Spanning Tree Protocol Commands