Accessing The Cli - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
You can also enter a question mark (?) after typing one or more characters of a word to list
the available command or parameters that begin with the letters, as shown in the following
example:
(switch) #show m?
mac-addr-table

2.2.8 Accessing the CLI

You can access the CLI by using a direct console connection or by using a telnet or SSH
connection from a remote management host.
For the initial connection, you must use a direct connection to the console port. You
cannot access the system remotely until the system has an IP address and subnet mask.
You can set the network configuration information manually, or you can configure the
system to accept these settings from a BOOTP or DHCP server on your network. For more
information, see
Overview
mac-address-table
Section 3.1 "Network Interface Commands" on page
v1.0, December 2005
monitor
3-1.
2-11