Netbios-Name-Server; Netbios-Node-Type - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
7.1.11.1 no domain-name
This command removes the domain name.
Format
Mode

7.1.12 netbios-name-server

This command configures NetBIOS Windows Internet Naming Service (WINS) name
servers that are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one
command line. Servers are listed in order of preference (address1 is the most preferred
server, address2 is the next most preferred server, and so on).
Default
Format
Mode
7.1.12.1 no netbios-name-server
This command removes the NetBIOS name server list.
Format
Mode

7.1.13 netbios-node-type

The command configures the NetBIOS node type for Microsoft Dynamic Host
Configuration Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid types
are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default
Format
Mode
DHCP Commands
no domain-name
DHCP Pool Config
none
netbios-name-server <address>
[<address2>...<address8>]
DHCP Pool Config
no netbios-name-server
DHCP Pool Config
none
netbios-node-type <type>
DHCP Pool Config
v1.0, December 2005
7-7