Spanning-Tree Max-Hops; Spanning-Tree Mst - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual
Prosafe 7300 series layer-3 switches, software version 4.0
Hide thumbs
Also See for ProSafe GSM7324:
- Reference manual (263 pages) ,
- Installation manual (26 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
5.1.10 spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the common and
internal spanning tree. The max-hops value is a range from 1 to 127.
Default
Format
Mode
5.1.10.1 no spanning-tree max-hops
This command sets the Bridge Max Hops parameter for the common and internal spanning
tree to the default value.
Format
Mode
5.1.11 spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning
tree instance or in the common and internal spanning tree. If you specify an
parameter that corresponds to an existing multiple spanning tree instance, the
configurations are done for that multiple spanning tree instance. If you specify 0 (defined
as the default CIST ID) as the
internal spanning tree instance.
If you specify the cost option, the command sets the path cost for this port within a
multiple spanning tree instance or the common and internal spanning tree instance,
depending on the
1 to 200000000 or auto. If you select auto the path cost value is set based on Link Speed.
If you specify the external-cost option, this command sets the external-path cost for MST
instance '0' i.e. CIST instance. You can set the external cost as a number in the range of 1
to 200000000 or auto. If you specify auto, the external path cost value is set based on Link
Speed.
If you specify the port-priority option, this command sets the priority for this port within
a specific multiple spanning tree instance or the common and internal spanning tree
instance, depending on the
range of 0 to 240 in increments of 16.
5-6
20
spanning-tree max-hops <1-127>
Global Config
no spanning-tree max-hops
Global Config
, the configurations are done for the common and
<mstid>
parameter. You can set the path cost as a number in the range of
<mstid>
parameter. The port-priority value is a number in the
<mstid>
v1.0, December 2005
Spanning Tree Protocol Commands
<mstid>
Advertisement
Chapters
Table of Contents
