Dot1X Re-Authentication; Dot1X System-Auth-Control; Dot1X Timeout - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

11.1.11 dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.
Default
Format
Mode
11.1.11.1 no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
Mode

11.1.12 dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By
default, the authentication support is disabled. While disabled, the dot1x configuration is
retained and can be changed, but is not activated.
Default
Format
Mode
11.1.12.1 no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
Mode

11.1.13 dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port. Depending on the token used and the value (in seconds) passed,
various timeout configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place.
The reauth-period must be a value in the range 1 - 65535.
11-6
disabled
dot1x re-authentication
Interface Config
no dot1x re-authentication
Interface Config
disabled
dot1x system-auth-control
Global Config
no dot1x system-auth-control
Global Config
Port-Based Access and Authentication Commands
v1.0, December 2005