Class-Map Rename; Match Any; Match Class-Map - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
13.3.1.1 no class-map
This command eliminates an existing DiffServ class. The
of an existing DiffServ class ( The class name 'default' is reserved and is not allowed here).
This command may be issued at any time; if the class is currently referenced by one or
more policies or by any other class, the delete action fails.
Format
Mode

13.3.2 class-map rename

This command changes the name of a DiffServ class. The
name of an existing DiffServ class. The
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the class (The
<class-map-name>
Format
Mode

13.3.3 match any

This command adds to the specified class definition a match condition whereby all packets
are considered to belong to the class.
Format
Mode

13.3.4 match class-map

This command adds to the specified class definition the set of match conditions defined
for another class. The
match conditions are being referenced by the specified class definition.
Format
Mode
The following ruules apply to this command:
• The parameters
• Only one other class may be referenced by a class.
Quality of Service (QoS) Commands
no class-map <class-map-name>
Global Config
<new-class-map-name>
'default' is reserved and must not be used here).
class-map rename <class-map-name> <new-class-map-
name>
Global Config
match any
Class-Map Config
is the name of an existing DiffServ class whose
<refclassname>
match class-map <refclassname>
Class-Map Config
and
<refclassname>
v1.0, December 2005
<class-map-name>
<class-map-name>
can not be the same.
<class-map-name>
is the name
is the
parameter is a case-
13-11