Dns-Server; Hardware-Address - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

7.1.5 dns-server

This command specifies the IP servers available to a DHCP client. Address parameters are
valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default
Format
Mode
7.1.5.1 no dns-server
This command removes the DNS Server list.
Format
Mode

7.1.6 hardware-address

This command specifies the hardware address of a DHCP client. Hardware-address is the
MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10
MB Ethernet and 6 for IEEE 802.
Default
Format
Mode
7.1.6.1 no hardware-address
This command removes the hardware address of the DHCP client.
Format
Mode
7-4
none
dns-server <address1> [<address2>....<address8>]
DHCP Pool Config
no dns-server
DHCP Pool Config
ethernet
hardware-address <hardwareaddress> [type]
DHCP Pool Config
no hardware-address
DHCP Pool Config
v1.0, December 2005
DHCP Commands