Ip Pimsm Crppreference; Ip Pimsm Message-Interval - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
15.4.2.1 no ip pimsm cbsrhashmasklength
Use this command to reset the CBSR hash mask length for a particular PIM-SM interface
to the default.
Format
Mode

15.4.3 ip pimsm crppreference

This command is used to configure the Candidate Rendezvous Point (CRP) for a particular
PIM-SM interface. The valid values are from (-1 to 255), and the value of -1 is used to
indicate that the local interface is not a Candidate RP interface.
The active router interface, with the highest IP Address and crppreference greater than -1,
is chosen as the CRP for the router. The default value is 0.
In the CRP advertisements sent to the bootstrap router (BSR), the router interface
advertises itself as the CRP for the group range 224.0.0.0 mask 240.0.0.0.
Default
Format
Mode
15.4.3.1 no ip pimsm crppreference
This command is used to reset the Candidate Rendezvous Point (CRP) for a particular
PIM-SM interface to the default value.
Format
Mode

15.4.4 ip pimsm message-interval

This command is used to configure the global join/prune interval for PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value
from 10 to 3600.
Default
Format
Mode
IP Multicast Commands
no ip pimsm
cbsrhashmasklength
Interface Config
0
ip pimsm crppreference <-1-255>
Interface Config
no ip pimsm
crppreference
Interface Config
60
ip pimsm message-interval <10-3600>
Global Config
v1.0, December 2005
15-21