Diffserv - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
The following rules apply when you create a DiffServ class:
• Each class can contain a maximum of one referenced (nested) class
• Class definitions do not support hierarchical service policies
A given class definition can contain a maximum of one reference to another class. You can
combine the reference with other match criteria. The referenced class is truly a reference
and not a copy since additions to a referenced class affect all classes that reference it.
Changes to any class definition currently referenced by any other class must result in valid
class definitions for all derived classes, otherwise the switch rejects the change. You can
remove a class reference from a class definition.
The only way to remove an individual match criterion from an existing class definition is
to delete the class and re-create it.
Note: The mark possibilities for policing include CoS, IP DSCP, and IP

13.2.1 diffserv

This command sets the DiffServ operational mode to active. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled,
Diffserv services are activated.
Format
Mode
13.2.1.1 no diffserv
This command sets the DiffServ operational mode to inactive. While disabled, the
DiffServ configuration is retained and can be changed, but it is not activated. When
enabled, Diffserv services are activated.
Format
Mode
Quality of Service (QoS) Commands
Precedence. While the latter two are only meaningful for IP packet types,
CoS marking is allowed for both IP and non-IP packets, since it updates
the 802.1p user priority field contained in the VLAN tag of the layer 2
packet header.
diffserv
Global Config
no diffserv
Global Config
v1.0, December 2005
13-9