Snmp-Server Enable Traps Violation; Snmp-Server Enable Traps - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual
Prosafe 7300 series layer-3 switches, software version 4.0
Hide thumbs
Also See for ProSafe GSM7324:
- Reference manual (263 pages) ,
- Installation manual (26 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
10.1.8 snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet with
a disallowed MAC address is received on a locked port.
Note: For other port security commands, see
Default
Format
Mode
10.1.8.1 no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
Mode
10.1.9 snmp-server enable traps
This command enables the Authentication Flag.
Default
Format
Mode
10.1.9.1 no snmp-server enable traps
This command disables the Authentication Flag.
Format
Mode
SNMP Commands
Commands" on page
9-1.
disabled
snmp-server enable traps violation
Interface Config
no snmp-server enable traps violation
Interface Config
enabled
snmp-server enable traps
Global Config
no snmp-server enable traps
Global Config
v1.0, December 2005
Section 9.1 "Port Security
10-5
Advertisement
Chapters
Table of Contents
