Ip Address; Ip Route - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.2.3 ip address

This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.
The value for
The value for
subnet mask of the interface. This changes the label IP address in
Format
Mode
14.2.3.1 no ip address
This command deletes an IP address from an interface. The value for
Address of the interface. The value for
which represents the Subnet Mask of the interface.
Format
Mode

14.2.4 ip route

This command configures a static route. The
<subnetmask>
hop router.
The
<preference>
value (sometimes called "administrative distance") of an individual static route. Among
routes to the same destination, the route with the lowest preference value is the route
entered into the forwarding database. By specifying the preference of a static route, the
user controls whether a static route is more or less preferred than routes from dynamic
routing protocols. The preference also controls whether a static route is more or less
preferred than other static routes to the same destination.
The following must be present before the static routes are visible:
• Enable ip routing globally.
• Enable ip routing for the interface.
• The associated link must also be up.
Routing Commands
is the IP Address of the interface.
<ipaddr>
is a 4-digit dotted-decimal number which represents the
<subnetmask>
ip address <ipaddr> <subnetmask> [secondary]
Interface Config
no ip address <ipaddr> <subnetmask> [secondary]
Interface Config
is a valid subnet mask. The
is an integer value from 1 to 255. The user can specify the preference
v1.0, December 2005
is a 4-digit dotted-decimal number
<subnetmask>
is a valid ip address. The
<ipaddr>
is a valid IP address of the next
<nextHopRtr>
.
show ip interface
is the IP
<ipaddr>
14-9