Bootp Relay Commands - D-Link xStack DGS-3324SRi Command Line Interface Reference Manual

The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config bootp_relay
config bootp_relay add ipif
config bootp_relay delete ipif
enable bootp_relay
disable bootp_relay
show bootp_relay
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure bootp relay status.
DGS-3324SRi:4#config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
DGS-3324SRi:4#
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
{hops <value 1-16> | time <sec 0-65535>}
<ipif_name 12> <ipaddr>
<ipif_name 12> <ipaddr>
{ipif <ipif_name 12>}
Used to configure the BOOTP relay feature of the Switch.
config bootp_relay {hops <value 1-16>} {time <sec 0-
65535>}
This command is used to configure the BOOTP relay feature.
hops <value 1-16> − Specifies the maximum number of relay
agent hops that the BOOTP packets can cross.
time <sec 0-65535> − If this time is exceeded, the Switch will
relay the BOOTP packet.
Only administrator-level users can issue this command.
BOOTP R
284
34
C
ELAY OMMANDS