D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 18

xStack Gigabit Layer 3 Switch Command Line Interface Manual
Purpose
Syntax
Description
Example command
Line Editing Key Usage
Delete
Backspace
Left Arrow
Right Arrow
Up Arrow
Down Arrow
Tab
Multiple Page Display Control Keys
Space
CTRL+c
ESC
n
p
q
r
a
Enter
{braces}
Encloses an optional value or set of optional arguments.
reset {[config | system]}
In the above syntax example, you have the option to specify
config or system. It is not necessary to specify either optional
value, however the effect of the system reset is dependent on
which, if any, value is specified. Therefore, with this example
there are three possible outcomes of performing a system
reset. See the following chapter, Basic Commands for more
details about the reset command.
Deletes the character under the cursor and then shifts the
remaining characters in the line to the left.
Deletes the character to the left of the cursor and shifts the
remaining characters in the line to the left.
Moves the cursor to the left.
Moves the cursor to the right.
Repeat the previously entered command. Each time the up
arrow is pressed, the command previous to that displayed
appears. This way it is possible to review the command history
for the current session. Use the down arrow to progress
sequentially forward through the command history list.
The down arrow will display the next command in the command
history entered in the current session. This displays each
command sequentially as it was entered. Use the up arrow to
review previous commands.
Shifts the cursor to the next field to the left.
Displays the next page.
Stops the display of remaining pages when multiple pages are to
be displayed.
Stops the display of remaining pages when multiple pages are to
be displayed.
Displays the next page.
Displays the previous page.
Stops the display of remaining pages when multiple pages are to
be displayed.
Refreshes the pages currently displayed.
Displays the remaining pages without pausing between pages.
Displays the next line or table entry.
10
reset config