show ospf virtual_link
Parameters
Restrictions
Usage Example:
To display the current OSPF virtual interface configuration:
DGS-3324SRi:4#show ospf virtual_link
Command: show ospf virtual_link
Virtual Interface Configuration
Transit
Area ID
--------------- ----------------------
10.0.0.0
Total Entries: 1
DGS-3324SRi:4#
xStack Gigabit Layer 3 Switch Command Line Interface Manual
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area's Area Border Router. This is
the router ID of the neighbor router.
None.
Virtual
Neighbor Router Interval
20.0.0.0
Hello
Dead
Authentication Link
Interval
------------ ----------- -------------------- ------------
10
60
None
329
Status
DOWN