D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 242

show access_profile
Restrictions
Example usage:
To display all of the currently configured access profiles on the Switch:
DGS-3324SRi:4#show access_profile
Command: show access_profile
Access Profile Table
Access Profile ID: 1
======================================================================
MASK Option :
VLAN
-----------
Access ID : 1
Ports: 1:1
----------- ------
Trinity 1
======================================================================
Access Profile ID: 2
======================================================================
MASK Option :
Procotol ID
--------------------
Access ID : 2
Ports: 1:2
--------------------
2
======================================================================
Access Profile ID: 3
======================================================================
MASK Option :
Offset 0-15 : 0xFFFFFFFF 0xFFFFFFFF 0xFFFFFFFF 0xFFFFFFFF
Offset 16-31 : 0x0000FFFF 0xFFFF0000 0x0000000F 0x0F000000
Access ID : 1
Ports: 1:1
Offset 0-15 : 0x11111111 0x11111111 0x11111111 0x11111111
Offset 16-31 : 0x00001111 0x11110000 0x00000001 0x01000000
======================================================================
Access Profile ID: 4
=====================================================================
MASK Option :
Class Flow Label
----- ----------
Access ID : 1
Ports: 1:4
----- ----------
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Entering this command without the profile_id parameter will
command the Switch to display all access profile entries.
Only administrator-level users can issue this command.
802.1p
------
Mode: Permit(replaced) priority: 1
Mode: Deny
Mode: Deny
Mode: Deny
TYPE : Ethernet
TYPE : IP
TYPE : Packet Content
TYPE : IPv6
234