D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 117

config 802.1p user_priority
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1 user priority on the Switch:
DGS-3324SRi:4# config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DGS-3324SRi:4#
show 802.1p user_priority
Purpose
Syntax
Description
xStack Gigabit Layer 3 Switch Command Line Interface Manual
config 802.1p user_priority <priority 0-7> <class_id 0-6>
The config 802.1p user_priority command is used to configure
the way the Switch will map an incoming packet, based on its
802.1p user priority tag, to one of the seven hardware classes of
service queues available on the Switch. The Switch's default is to
map the incoming 802.1p priority values to the seven hardware
priority classes of service according to the following chart:
802.1p Switch Hardware
Value Priority Queue
--------- ------------------
0
1
2
3
4
5
6
7
<priority 0-7> − Specifies which of the eight 802.1p priority tags (0
through 7) you want to map to one of the Switch's hardware
priority classes of service (<class_id>, 0 through 6).
<class_id 0-6> − Specifies which of the Switch's hardware priority
classes of service the 802.1p priority tags (specified above) will be
mapped to.
Only administrator-level users can issue this command.
Used to display the current 802.1p user priority tags to hardware
priority class of service mapping in use by the Switch.
show 802.1p user_priority
The show 802.1p user_priority command will display the current
802.1p user priority tags to hardware priority classes of service
mapping in use by the Switch.
2
0
1
3
4
5
6
6
109