D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 28

config serial_port
Restrictions
Example usage:
To configure baud rate:
enable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable pausing of the screen display when the command output reaches the end of the page:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
be open with no user input.
2_minutes − The console will log out the current user if
•
there is no user input for 2 minutes.
5_minutes − The console will log out the current user if
•
there is no user input for 5 minutes.
10_minutes − The console will log out the current user if
•
there is no user input for 10 minutes.
15_minutes − The console will log out the current user if
•
there is no user input for 15 minutes.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DGS-3324SRi:4#
Used to pause the scrolling of the console screen when the show
command displays more than one page.
enable clipaging
This command is used when issuing the show command which
causes the console screen to rapidly scroll through several
pages. This command will cause the console to pause at the end
of each page. The default setting is enable.
None.
Only administrator-level users can issue this command.
DGS-3324SRi:4#enable clipaging
Command: enable clipaging
Success.
DGS-3324SRi:4#
20