D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 319

DGS-3324SRi:4#enable ospf
Command: enable ospf
Success.
DGS-3324SRi:4#
disable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To disable OSPF on the Switch:
DGS-3324SRi:4#disable ospf
Command: disable ospf
Success.
DGS-3324SRi:4#
show ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to disable OSPF on the Switch.
disable ospf
This command, in combination with the enable ospf
command above, is used to enable and disable OSPF on the
Switch.
None.
Only administrator-level users can issue this command.
Used to display the current OSPF state on the Switch.
show ospf
This command will display the current state of OSPF on the
Switch, divided into the following categories:
General OSPF settings
OSPF Interface settings
OSPF Area settings
OSPF Virtual Interface settings
OSPF Area Aggregation settings
OSPF Host Route settings
None.
None.
311