Broadcast Storm Control Commands - D-Link xStack DGS-3324SRi Command Line Interface Reference Manual

The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
config traffic control
show traffic control
Each command is listed, in detail, in the following sections.
config traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
B
ROADCAST
Parameters
[<storm_grouplist> | all] {broadcast [enable | disable] | multicast
[enable | disable] | dlf [enable | disable] | threshold <value 0-255>}
{group_list <storm_grouplist>}
Used to configure broadcast/multicast traffic control.
config traffic control [<storm_grouplist> | all] {broadcast
[enable | disable] | multicast [enable | disable] | dlf [enable |
disable] | threshold <value 0-255>}
This command is used to configure broadcast storm control.
<storm_grouplist> − Used to specify a broadcast storm control
group. This is specified by listing the lowest switch number and
the beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Specifies all broadcast storm control groups on the Switch.
broadcast [enable | disable] − Enables or disables broadcast
storm control.
multicast [enable | disable] − Enables or disables multicast storm
control.
dlf [enable | disable] − Enables or disables dlf traffic control.
threshold <value 0-255> − The upper threshold at which the
specified traffic control is switched on. The <value> is the number
of broadcast/multicast/dlf packets, in kilopackets per second
(Kpps), received by the Switch that will trigger the storm traffic
control measures.
Only administrator-level users can issue this command.
S C
TORM ONTROL
101
12
C
OMMANDS