D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 32

reboot
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restart the Switch:
reset
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restore all of the Switch's parameters to their default values:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
NOTE: The DGS-3324SRi does not support a change in box mode from
Auto to Static.
Used to restart the Switch.
reboot
This command is used to restart the Switch.
None.
None.
DGS-3324SRi:4#reboot
Command: reboot
Are you sure want to proceed with the system reboot? (y/n)
Please wait, the Switch is rebooting...
Used to reset the Switch to the factory default settings.
reset {[config | system]}
This command is used to restore the Switch's configuration to the
default settings assigned from the factory.
config − If the keyword 'config' is specified, all of the factory
default settings are restored on the Switch including the IP
address, user accounts, and the Switch history log. The Switch
will not save or reboot.
system − If the keyword 'system' is specified all of the factory
default settings are restored on the Switch. The Switch will save
and reboot after the settings are changed to default. Rebooting
will clear all entries in the Forwarding Data Base.
If no parameter is specified, the Switch's current IP address, user
accounts, and the Switch history log are not changed. All other
parameters are restored to the factory default settings. The Switch
will not save or reboot.
Only administrator-level users can issue this command.
DGS-3324SRi:4#reset config
Command: reset config
24