D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 79

config syslog host
Restrictions
Example usage:
To configure a syslog host:
config syslog host all
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
host.
ipaddress <ipaddr> − Specifies the IP address of the remote host
where syslog messages will be sent.
state [enable | disable] − Allows the sending of syslog messages
to the remote host, specified above, to be enabled and disabled.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config syslog host 1 severity all
Command: config syslog host 1 severity all
Success.
DGS-3324SRi:4##config syslog host 1 facility local0
Command: config syslog host 1 facility local0
Success.
DGS-3324SRi:4# config syslog host 1 udp_port 6000
Command: config syslog host 1 udp_port 6000
Success.
DGS-3324SRi:4# config syslog host 1 ipaddress 10.44.67.8
Command: config syslog host 1 ipaddress 10.44.67.8
Success.
DGS-3324SRi:4# config syslog host 1 state enable
Command: config syslog host 1 state enable
Success.
DGS-3324SRi:4#
Used to configure the syslog protocol to send system log data to a
remote host.
config syslog host all [severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | state [enable |
disable]]
The config syslog host all command is used to configure the
syslog protocol to send system log information to a remote host.
all − Specifies that the command will be applied to all hosts.
severity − Severity level indicator, as described below:
Bold font indicates that the corresponding severity level is
currently supported on the Switch.
Numerical Severity
71