D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 254

show sim
Parameters
Restrictions
Example usage:
To show the SIM information in detail:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Firmware Version - Displays the current Firmware version on the
Switch.
Device Name - Displays the user-defined device name on the
Switch.
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or
Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the
Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including
Commander, Member or Candidate. A stand-alone switch will
always have the candidate role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold
discovery results before dropping it or utilizing it.
candidates <candidate_id 1-100> - Entering this parameter will
display information concerning candidates of the SIM group. To
view a specific candidate, include that candidate's id number, listed
from 1 to 100.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a
specific member, include that member's ID number, listed from 1 to
32.
group commander_mac <macaddr> - Entering this parameter will
display information concerning the SIM group of a commander
device, identified by its MAC address.
neighbor – Entering this parameter will display neighboring devices
of the Switch. A SIM neighbor is defined as a switch that is
physically connected to the Switch but is not part of the SIM group.
This screen will produce the following results:
Port – Displays the physical port number of the commander
•
switch where the uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor
•
switch.
Role – Displays the role (CS, CaS, MS) of the neighbor
•
switch.
Only administrator-level users can issue this command.
246