D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 198

Success.
DGS-3324SRi:4#
show ssh user authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
DGS-3324SRi:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
UserName
--------------------------
Trinity
DGS-3324SRi:4#
config ssh algorithm
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to display the SSH user setting.
show ssh user authmode
This command allows you to display the current SSH user setting.
None.
None.
Authentication
--------------------------
Publickey
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 |
arcfour | blowfish | cast128 | twofish128 | twofish192 |
twofish256 | MD5 | SHA1 | DSA | RSA] [enable | disable]
This command allows you to configure the desired type of SSH
algorithm used for authentication encryption.
3DES – This parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced
190