D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 318

Command
show ospf all
create ospf virtual_link
config ospf virtual_link
delete ospf virtual_link
show ospf virtual_link
Each command is listed, in detail, in the following sections.
config ospf router_id
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To configure the OSPF router ID:
enable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To enable OSPF on the Switch:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
<area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple
<password 8> | md5 <key_id 1-255>]}
<area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple
<password 8> | md5 <key_id 1-255>]}
<area_id> <neighbor_id>
<area_id> <neighbor_id>
Used to configure the OSPF router ID.
config ospf router_id <ipaddr>
This command is used to configure the OSPF router ID.
<ipaddr> − The IP address of the OSPF router.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3324SRi:4#
Used to enable OSPF on the Switch.
enable ospf
This command, in combination with the disable ospf
command below, is used to enable and disable OSPF on the
Switch.
None.
Only administrator-level users can issue this command.
310