D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 30

disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
enable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable HTTP and configure port number:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the
Switch.
None.
Only administrator-level users can issue this command.
DGS-3324SRi:4#disable telnet
Command: disable telnet
Success.
DGS-3324SRi:4#
Used to enable the HTTP-based management software on the
Switch.
enable web <tcp_port_number 1-65535>
This command is used to enable the Web-based management
software on the Switch. The user can specify the TCP port
number the Switch will use to listen for Telnet requests.
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The "well-known" port for
the Web-based management software is 80.
Only administrator-level users can issue this command.
DGS-3324SRi:4#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DGS-3324SRi:4#
22