D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 208

Command
statistics
show auth_statistics
Each command is listed, in detail, in the following sections.
enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1x switch wide:
DGS-3324SRi:4#enable 802.1x
Command: enable 802.1x
Success.
DGS-3324SRi:4#
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
DGS-3324SRi:4#disable 802.1x
Command: disable 802.1x
Success.
DGS-3324SRi:4#
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
{ports [<portlist> | all]}
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Network
Access control server application on the Switch. To select
between port-based or MAC-based, use the config 802.1x
auth_mode command.
None.
Only administrator-level users can issue this command.
Used to disable the 802.1x server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1x
Network Access control server application on the Switch. To
select between port-based or MAC-based, use the config
802.1x auth_mode command.
None.
Only administrator-level users can issue this command.
200