D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 325

show ospf host_route
Parameters
Restrictions
Usage Example:
To display the current OSPF host route table:
DGS-3324SRi:4#show ospf host_route
Command: show ospf host_route
Host Address
---------------
10.48.73.21
10.48.74.122
Total Entries: 2
DGS-3324SRi:4#
create ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create an OSPF area aggregation:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
<ipaddr> − The IP address of the host.
None.
Metric
---------------
2
1
Used to configure OSPF area aggregation settings.
create ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enable | disable]}
This command is used to create an OSPF area aggregation.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the
OSPF Area.
lsdb_type summary − The type of address aggregation.
advertise [enable | disable] − Allows for the advertisement trigger to
be enabled or disabled.
Only administrator-level users can issue this command.
Area_ID
-----------
10.1.1.1
10.1.1.1
317