D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 29

disable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable pausing of the screen display when show command output reaches the end of the page:
enable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to disable the pausing of the console screen scrolling at
the end of each page when the show command displays more
than one screen of information.
disable clipaging
This command is used to disable the pausing of the console
screen at the end of each page when the show command
would display more than one screen of information.
None.
Only administrator-level users can issue this command.
DGS-3324SRi:4#disable clipaging
Command: disable clipaging
Success.
DGS-3324SRi:4#
Used to enable communication with and management of the
Switch using the Telnet protocol.
enable telnet <tcp_port_number 1-65535>
This command is used to enable the Telnet protocol on the
Switch. The user can specify the TCP or UDP port number the
Switch will use to listen for Telnet requests.
<tcp_port_number 1-65535>
ports are numbered between 1 and 65535. The "well-known"
TCP port for the Telnet protocol is 23.
Only administrator-level users can issue this command.
DGS-3324SRi:4#enable telnet 23
Command: enable telnet 23
Success.
DGS-3324SRi:4#
−
The TCP port number. TCP
21