D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 279

show vrrp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To view the global VRRP settings currently implemented on the Switch (VRRP Enabled):
DGS-3324SRi:4#show vrrp
Command: show vrrp
Global VRRP
Non-owner response PING : Disabled
Interface Name
Authentication type
Total Entries : 1
DGS-3324SRi:4#
delete vrrp
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
To view the VRRP settings set on the Switch.
show vrrp ipif <ipif_name 12> vrid <vrid 1-255>
This command is used to view current VRRP settings of the VRRP
Operations table.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to view the VRRP settings. This IP interface must
be assigned to a VLAN on the Switch.
vrid <vrid 1-255> - Enter the VRRP ID of a VRRP entry for which to
view these settings.
Only administrator-level users can issue this command.
VRID
Virtual IP Address
Virtual MAC Address
Virtual Router State
State
Priority
Master IP Address
Critical IP Address
Checking Critical IP
Advertisement Interval : 1 secs
Preempt Mode
Virtual Router Up Time : 2754089 centi-secs
Used to delete a vrrp entry from the switch.
delete vrrp {vrid <vrid 1-255> ipif <ipif_name 12>}
This command is used to remove a VRRP router running on a local
device.
vrid <vrid 1-255> - Enter the VRRP ID of the virtual router to be
d l t d N t
:Enabled
: System
: No Authentication
: 2
: 10.53.13.3
: 00-00-5E-00-01-02
: Master
: Enabled
: 255
: 10.53.13.3
: 0.0.0.0
: Disabled
: True
t i thi t
271
ill d l t ll VRRP t i