D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 90

config stp ports
Restrictions
Example usage:
To configure STP with path cost 19, hellotime set to 5 seconds, migration enable, and state enable for ports 1-5 of
module 1.
DGS-3324SRi:4#config stp ports 1:1-1:5 externalCost 19 hellotime
5 migrate yes state enable
Command: config stp ports 1:1-1:5 externalCost 19 hellotime 5
migrate yes state enable
Success.
DGS-3324SRi:4#
create stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a spanning tree instance 2:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
forced to half-duplex operation) the p2p status changes to operate
as if the p2p value were false. The default setting for this
parameter is auto.
state [enable | disable] − Allows STP to be enabled or disabled for
the ports specified in the port list. The default is enable.
Only administrator-level users can issue this command.
Used to create a STP instance ID for MSTP.
create stp instance_id <value 1-15>
This command allows the user to create a STP instance ID for the
Multiple Spanning Tree Protocol. There are 16 STP instances on
the Switch (one internal CIST, unchangeable) and the user may
create up to 15 instance IDs for the Switch.
<value 1-15> - Enter a value between 1 and 15 to identify the
Spanning Tree instance on the Switch.
Only administrator-level users can issue this command.
DGS-3324SRi:4#create stp instance_id 2
Command: create stp instance_id 2
Success.
DGS-3324SRi:4#
82