D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 212

SuppTimeout
ServerTimeout
MaxReq
ReAuthPeriod
ReAuthenticate
CTRL+C ESC q
show 802.1x auth_state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the 802.1x auth state for Port-based 802.1x:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
: 30 sec
: 30 sec
: 2 times
: 3600 sec
: Disabled
Quit SPACE n Next Page
Used to display the current authentication state of the 802.1x
server on the Switch.
show 802.1x auth_state {ports [<portlist> | all]}
The show 802.1x auth_state command is used to display the
current authentication state of the 802.1x Port-based Network
Access Control server application on the Switch.
The following details what is displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting /
Authenticating / Authenticated / Held / ForceAuth / ForceUnauth
− Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize /
Success / Timeout − Shows the current state of the Backend
Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized
means that the user was not authenticated, and cannot access
the network.
ports <portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4 specifies all of the
ports between port 3 and port 4 − in numerical order.
all – denotes all ports on the Switch
Only administrator-level users can issue this command.
Enter Next Entry a
204
All