D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 166

DGS-3324SRi:4#show mac_notification
Command: show mac_notification
Global Mac Notification Settings
State
Interval
History Size : 1
DGS-3324SRi:4#
show mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display all port's MAC address table notification status settings:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
: Enabled
: 1
Used to display the Switch's MAC address table notification status
settings.
show mac_notification ports <portlist>
This command is used to display the Switch's MAC address table
notification status settings.
<portlist> - Specify a port or group of ports to be viewed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
Entering this command without the parameter will display the MAC
notification table for all ports.
None
158