D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 93

config stp mst_config_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the MSTP region of the Switch with revision_level 10 and the name "Trinity":
DGS-3324SRi:4#config stp mst_config_id revision_level 10 name Trinity
Command : config stp mst_config_id revision_level 10 name Trinity
Success.
DGS-3324SRi:4#
config stp mst_ports
Purpose
Syntax
Description
xStack Gigabit Layer 3 Switch Command Line Interface Manual
DGS-3324SRi:4#config stp priority 4096 instance_id 2
Command : config stp priority 4096 instance_id 2
Success.
DGS-3324SRi:4#
Used to update the MSTP configuration identification.
config stp mst_config_id {revision_level <int 0-65535> | name
<string>
This command will uniquely identify the MSTP configuration
currently configured on the Switch. Information entered here will
be attached to BDPU packets as an identifier for the MSTP region
to which it belongs. Switches having the same revision_level and
name will be considered as part of the same MSTP region.
revision_level <int 0-65535>– Enter a number between 0 and
65535 to identify the MSTP region. This value, along with the
name will identify the MSTP region configured on the Switch. The
default setting is 0.
name <string> - Enter an alphanumeric string of up to 32
characters to uniquely identify the MSTP region on the Switch.
This name, along with the revision_level value will identify the
MSTP region configured on the Switch. If no name is entered, the
default name will be the MAC address of the device.
Only administrator-level users can issue this command.
Used to update the port configuration for a MSTP instance.
config stp mst_ports <portlist> instance_id <value 0-15>
{internalCost [auto | <value 1-20000000>] `priority <value 0-
240>}
This command will update the port configuration for a STP
instance_id. If a loop occurs, the MSTP function will use the port
priority to select an interface to put into the forwarding state. Set a
85