D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 150

config igmp
Description
Parameters
Restrictions
Example Usage:
To configure the IGMPv3 for all IP interfaces.
DGS-3324SRi:4#config igmp all version 3 state enable
Command: config igmp all version 3 state enable
Success.
DGS-3324SRi:4#
show igmp
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
25> | robustness_variable <value 1-255> |
last_member_query_interval <value 1-25> | state [enable |
disable]}
This command allows you to configure IGMP on the Switch.
<ipif_name 12> − The name of the IP interface for which you
want to configure IGMP.
all − Specifies all the IP interfaces on the Switch.
version <value 1-3> − Select the IGMP version number.
query_interval <sec 1-31744> − The time in seconds between
general query transmissions, in seconds.
max_response_time <sec 1-25> − Enter the maximum time in
seconds that the Switch will wait for reports from members.
robustness_variable <value 1-255> − This value states the
permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> − The Max Response
Time inserted into Group-Specific Queries and Group-and-
Source specific queries sent in response to Leave Group
messages, and is also the amount of time between Group-
Specific Query and Group-and-Source specific query messages.
The default is 1 second.
state [enable | disable] − Enables or disables IGMP for the
specified IP interface.
Only administrator-level users can issue this command.
Used to display the IGMP configuration for the Switch of for a
specified IP interface.
show igmp {ipif <ipif_name 12>}
This command will display the IGMP configuration for the Switch
if no IP interface name is specified. If an IP interface name is
specified, the command will display the IGMP configuration for
that IP interface.
<ipif_name 12> − The name of the IP interface for which the
IGMP configuration will be displayed.
142