D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 134

config gvrp
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DGS-3324SRi:4#config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DGS-3324SRi:4#
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DGS-3324SRi:4#enable gvrp
Command: enable gvrp
Success.
DGS-3324SRi:4#
xStack Gigabit Layer 3 Switch Command Line Interface Manual
all − Specifies all of the ports on the Switch.
state [enable | disable] − Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter
states the frame type that will be accepted by the Switch for this
function. Tagged_only implies that only VLAN tagged frames will
be accepted, while admit_all implies tagged and untagged frames
will be accepted by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Only administrator-level users can issue this command.
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable
and disable GVRP globally on the Switch, without changing the
GVRP configuration on the Switch.
None.
Only administrator-level users can issue this command.
126