DGS-3324SRi:4#disable syslog
Command: disable syslog
Success.
DGS-3324SRi:4#
show syslog
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:
DGS-3324SRi:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3324SRi:4#
create syslog host
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to display the syslog protocol status as enabled or disabled.
show syslog
The show syslog command displays the syslog status as
enabled or disabled.
None.
None.
Used to create a new syslog host.
create syslog host [<index 1-4>] {severity [informational |
warning | all] facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]
The create syslog host command is used to create a new syslog
host.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
severity − Severity level indicator, as shown below:
Bold font indicates that the corresponding severity level is
currently supported on the Switch.
Numerical
Code
0
Emergency: system is unusable
Severity
66