D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 130

xStack Gigabit Layer 3 Switch Command Line Interface Manual
create vlan
Corporation (DEC) Local Area Transport (LAT) protocol.
protocol–decOther - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Digital Equipment
Corporation (DEC) Protocol.
protocol–sna802dot2 - Using this parameter will instruct
the Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Systems Network
Architecture (SNA) 802.2 Protocol.
protocol–snaEthernet2 - Using this parameter will instruct
the Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Systems Network
Architecture (SNA) Ethernet II Protocol.
protocol-netBios - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the NetBIOS Protocol.
protocol-xns - Using this parameter will instruct the Switch
to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by the Xerox Network Systems (XNS)
Protocol.
protocol-vines - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Banyan Virtual
Intergrated Network Service (VINES) Protocol.
protocol-ipV6 - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Internet Protocol Version
6 (IPv6) Protocol.
protocol–userDefined - Using this parameter will instruct
the Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol defined by the
user. This packet header information is defined by entering
the following information:
<hex 0x0-0xffff> - Specifies that the VLAN will
only accept packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
encap [ethernet | llc | snap | all] – Specifies that the Switch
will examine the octet of the packet header referring to one of
the protocols listed (Ethernet, LLC or SNAP), looking for a
match of the hexadecimal value previously entered . all will
instruct the Switch to examine the total packet header. After a
match is found, the Switch will forward the packet to this
VLAN.
protocol-rarp - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
122