D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 326

DGS-3324SRi:4#create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DGS-3324SRi:4#
delete ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To configure the OSPF area aggregation settings:
DGS-3324SRi:4#delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
Command: delete ospf aggregation 10.1.1.1 10.48.76..122/16 lsdb_type summary
Success.
DGS-3324SRi:4#
config ospf aggregation
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to delete an OSPF area aggregation configuration.
delete ospf aggregation <area_id> <network_address>
lsdb_type summary
This command is used to delete an OSPF area aggregation
configuration.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
Only administrator-level users can issue this command.
Used to configure the OSPF area aggregation settings.
config ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enable | disable]}
This command is used to configure the OSPF area aggregation
settings.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
318