D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 54

DGS-3324SRi:4#create snmp host 10.48.74.100 v3 auth_priv public
Command: create snmp host 10.48.74.100 v3 auth_priv public
Success.
DGS-3324SRi:4#
delete snmp host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an SNMP host entry:
DGS-3324SRi:4#delete snmp host 10.48.74.100
Command: delete snmp host 10.48.74.100
Success.
DGS-3324SRi:4#
show snmp host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to remove a recipient of SNMP traps generated by the
Switch's SNMP agent.
delete snmp host <ipaddr>
The delete snmp host command deletes a recipient of SNMP
traps generated by the Switch's SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch's SNMP agent.
Only administrator-level users can issue this command.
Used to display the recipient of SNMP traps generated by the
Switch's SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP
addresses and configuration information of remote SNMP
managers that are designated as recipients of SNMP traps that
are generated by the Switch's SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch's SNMP agent.
None.
46