D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 55

DGS-3324SRi:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address
---------------
10.48.76.23
10.48.74.100
Total Entries: 2
DGS-3324SRi:4#
create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the trusted host:
DGS-3324SRi:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3324SRi:4#
show trusted_host
Purpose
Syntax
Description
xStack Gigabit Layer 3 Switch Command Line Interface Manual
SNMP Version
--------------------- ------------------------------
V2c
V3 authpriv
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host.
The Switch allows you to specify up to four IP addresses that are
allowed to manage the Switch via in-band SNMP or TELNET
based management software. These IP addresses must be
members of the Management VLAN. If no IP addresses are
specified, then there is nothing to prevent any IP address from
accessing the Switch, provided the user knows the Username
and Password.
<ipaddr> − The IP address of the trusted host.
Only administrator-level users can issue this command.
Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
show trusted_host
This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
Community Name/SNMPv3 User Name
private
public
47