D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 118

show 802.1p user_priority
Parameters
Restrictions
Example usage:
To show 802.1p user priority:
DGS-3324SRi:4# show 802.1p user_priority
Command: show 802.1p user_priority
COS Class of Traffic
Priority-0 -> <Class-2>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>
Priority-6 -> <Class-6>
Priority-7 -> <Class-6>
DGS-3324SRi:4#
config 802.1p default_priority
Purpose
Syntax
Description
Parameters
Restrictions
xStack Gigabit Layer 3 Switch Command Line Interface Manual
None.
None.
Used to specify default priority settings on the Switch. Untagged
packets that are received by the Switch will be assigned a priority
tag in its priority field using this command.
config 802.1p default_priority [<portlist> | all] <priority 0-7>
The config 802.1p default_priority command allows you to
specify the 802.1p priority value an untagged, incoming packet will
be assigned before being forwarded to its destination.
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Specifies that the config 802.1p default_priority command
will be applied to all ports on the Switch.
<priority 0-7> − Specifies the 802.1p priority tag that an untagged,
incoming packet will be given before being forwarded to its
destination.
Only administrator-level users can issue this command.
110