D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 139

DGS-3324SRi:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3324SRi:4#
delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
DGS-3324SRi:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3324SRi:4#
config link_aggregation
Purpose
Syntax
Description
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-32>
This command is used to delete a previously configured link
aggregation group.
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
Only administrator-level users can issue this command.
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-32> {master_port
<port> | ports <portlist> | state [enable | disable]
This command allows you to configure a link aggregation group that
was created with the create link_aggregation command above. The
DGS-3324SRi supports link aggregation cross box which specifies
that link aggregation groups may be spread over multiple switches
in the Switching stack.
131