D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 158

config router_ports_forbidden
Restrictions
Example usage:
To set up forbidden router ports:
DGS-3324SRi:4#config router_ports_forbidden default add 2:1-2:10
Command: config router_ports_forbidden default add 2:1-2:10
Success.
DGS-3324SRi:4#
show router_ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the router ports.
xStack Gigabit Layer 3 Switch Command Line Interface Manual
switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order.
Only administrator-level users can issue this command.
Used to display the currently configured router ports on the
Switch.
show router_ports {vlan <vlan_name 32>} {static | dynamic |
forbidden}
This command will display the router ports currently configured on
the Switch.
vlan <vlan_name 32> − The name of the VLAN on which the
router port resides.
static − Displays router ports that have been statically configured.
dynamic − Displays router ports that have been dynamically
configured.
forbidden – Displays router ports that have been labeled as
forbidden.
None.
150