Rip Commands - D-Link xStack DGS-3324SRi Command Line Interface Reference Manual

High-density layer 3 intelligent gigabit switch
Hide thumbs Also See for xStack DGS-3324SRi:
Table of Contents

Advertisement

The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config rip
enable rip
disable rip
show rip
Each command is listed, in detail, in the following sections.
config rip
Purpose
Syntax
Description
Parameters
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
[ipif <ipif_name 12> | all] {authentication [enable <password
16> | disable] | tx_mode [disable | v1_only | v1_compatible |
v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable]
state [enable | disable]}
ipif <ipif_name 12>
Used to configure RIP on the Switch.
config rip [ipif <ipif_name 12> | all] {authentication [enable
<password 16> | disable] | tx_mode [disable | v1_only |
v1_compatible | v2_only] | rx_mode [v1_only | v2_only |
v1_or_v2 | disable] state [enable | disable]}
This command is used to configure RIP on the Switch.
<ipif_name 12> − The name of the IP interface.
all – To configure all RIP receiving mode for all IP interfaces.
authentication [enable | disable] − Enables or disables
authentication for RIP on the Switch.
<password 16> − Allows the specification of a case-
sensitive password.
tx_mode − Determines how received RIP packets will be
interpreted – as RIP version V1 only, V2 Only, or V1 Compatible
(V1 and V2). This entry specifies which version of the RIP
protocol will be used to transfer RIP packets. The disabled entry
prevents the reception of RIP packets.
disable − Prevents the transmission of RIP packets.
v1_only − Specifies that only RIP v1 packets will be
transmitted.
v1_compatible – Specifies that only RIP v1 compatible
packets will be transmitted.
v2_only - Specifies that only RIP v2 packets will be
transmitted.
rx_mode − Determines how received RIP packets will be
interpreted – as RIP version V1 only, V2 Only, or V1 or V2.
This entry specifies which version of the RIP protocol will be
used to receive RIP packets. The Disabled entry prevents the
292
36
RIP C
OMMANDS

Advertisement

Table of Contents
loading

Table of Contents