D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 82

delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
DGS-3324SRi:4#delete syslog host 4
Command: delete syslog host 4
Success.
DGS-3324SRi:4#
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
DGS-3324SRi:4# config syslog host all ipaddress 10.44.67.8
Command: config syslog host all ipaddress 10.44.67.8
Success.
DGS-3324SRi:4# config syslog host all state enable
Command: config syslog host all state enable
Success.
DGS-3324SRi:4#
Used to remove a syslog host, that has been previously
configured, from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog
host that has been previously configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
all − Specifies that all syslog hosts will be deleted.
Only administrator-level users can issue this command.
Used to display the syslog hosts currently configured on the
Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
74