D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 288

config route redistribute dst ospf src
Parameters
Restrictions
Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will
be redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the
routing information that will be redistributed.
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To configure route redistributions:
DGS-3324SRi:4#config route redistribute dst ospf src all metric 2
Command: config route redistribute dst ospf src all metric 2
Success.
DGS-3324SRi:4#
config route redistribute dst rip src
Purpose
Syntax
xStack Gigabit Layer 3 Switch Command Line Interface Manual
RIP. Routing information entered into the Static Routing Table on
the local switch is also redistributed.
src [static | rip | local] − Allows the selection of the protocol of the
source device.
mettype − allows the selection of one of the methods for calculating
the metric value.
Type-1 calculates the metric (for RIP to OSPF) by adding the
•
destination's interface cost to the metric entered in the Metric
field.
Type-2 uses the metric entered in the Metric field without
•
change. This field applies only when the destination field is
OSPF.
metric <value 0-65535> − Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Route Source Metric
RIP 0 to 16777214
Static 0 to 16777214
Local 0 to 16777214
Used configure route redistribution settings for the exchange of
RIP routes to OSPF routes on the Switch.
config route redistribute dst rip src [local | static | ospf | [all |
i t l |
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2
t l | t 1 | t
280
2 | i t 1 | i t 2]]