D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 35

config ports
Restrictions
Example usage:
To configure the speed of port 3 of unit 1 to be 10 Mbps, full duplex, learning and state enable:
DGS-3324SRi:4#config ports 1:1-1:3 speed 10_full learning enable state
enable
Command: config ports 1:1-1:3 speed 10_full learning enable state
enable
Success.
DGS-3324SRi:4#
show ports
Purpose
Syntax
Description
Parameters
Restrictions
xStack Gigabit Layer 3 Switch Command Line Interface Manual
one connection is set for 1000 master, the other side of the
connection must be set for 1000 slave. Any other configuration will
result in a link down status for both ports.
flow_control [enable | disable] – Enable or disable flow control for
the specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of ports.
state [enable | disable] − Enables or disables the specified range
of ports.
description <desc 32> - Enter an alphanumeric string of no more
than 32 characters to describe a selected port interface.
clear – Enter this command to clear the port description of the
selected port(s).
Only administrator-level users can issue this command.
Used to display the current configuration of a range of ports.
show ports <portlist> {description}
This command is used to display the current configuration of a
range of ports.
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
{description} – Adding this parameter to the command will allow
the user to view previously configured descriptions set on various
ports on the Switch.
None.
27