D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 265

To manually set system time and date settings:
DGS-3324SRi:4#config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DGS-3324SRi:4#
config time zone
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure time zone settings:
DGS-3324SRi:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DGS-3324SRi:4#
config dst
Purpose
Syntax
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to determine the time zone used in order to adjust the
system clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> |
min <minute 0-59>}
This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour <gmt_hour 0-13> – Select the number hours different from
GMT.
min <minute 0-59> – Select the number of minutes difference
added or subtracted to adjust the time zone.
Only administrator-level users can issue this command.
Used to enable and configure time adjustments to allow for the
use of Daylight Savings Time (DST).
config dst [disable | repeating {s_week <start_week 1-
4,last> | s_day <start_day sun-sat>| s_mth <start_mth 1-12>
| s_time <start_time hh:mm> | e_week <end_week 1-4,last>
| e-day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual
{s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60
257