Dhcp Relay Commands; Enable Dhcp_Relay - D-Link DGS-1100-06/ME Cli Reference Manual

The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable dhcp_relay

disable dhcp_relay
config dhcp_relay add
ipif system
config dhcp_relay
delete ipif system
config dhcp_relay
config dhcp_relay
option_82
show dhcp_relay
enable
dhcp_local_relay
disable
dhcp_local_relay
config dhcp_local_relay
show dhcp_local_relay
enable dhcpv6_relay
disable dhcpv6_relay
show dhcpv6_relay
config dhcpv6_relay
config dhcpv6_relay
hop_count
Each command is listed in detail, as follows:
enable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<ipaddr>
<ipaddr>
hops <value 1-16>
[check [enable | disable] | policy [drop | keep | replace] | remote_id [default |
user_define <string 32>] | state [enable | disable]]
{ipif}
vlan <vlan_name> | vlanid <vidlist>] state[enable | disable]
{ipif system}
[add | delete] ipif System <ipv6_addr>
<value 1-32>
To enable DHCP Relay server on the Switch
enable dhcp_relay
The enable dhcp_relay command sets the DHCP Relay to be
globally enabled on the Switch and on all existing VLANs.
None.
Only Administrator or operate-level users can issue this command.

DHCP RELAY COMMANDS

74
12