File System Commands - D-Link xStack DGS-3324SRi Command Line Interface Reference Manual

File System commands are used to configure files stored on a storage accessory located in the Switch, such as a CompactFlash
card that can be used with the DGS-3324SRi only. These commands are based on DOS commands, cannot be used with the
Switch's internal memory and are specific to the DGS-3324SRi member of the xStack family.
The File System commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show storage_media_info
cd
copy
dir
erase
format
md
mkdir
rd
ren
rename
rmdir
Each command is listed, in detail, in the following sections.
show storage_media_info
Purpose
Syntax
Description
Parameters
Restrictions
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Parameters
[<pathname 64>]
<source_path_filename 64> <target path_filename>
[<pathname 64>]
<pathname 64>
<drive> [FAT16] [fast | full | full_with_MBR] {<label_name
8>}
<pathname 64>
<pathname 64>
<pathname 64>
<source_path_filename 64> <target path_filename>
<source_path_filename 64> <target path_filename>
<pathname 64>
Used to view media on the storage media accessory.
show storage_media_info
This command will display information stored on the storage media
accessory. This command will display the following information:
Drive: The name of the drive of the storage media accessory.
Media_Type: Description of the type of storage media accessory
currently in use.
Size: Description of the size of memory space available on the
storage media accessory.
Label: Description assigned to this storage media accessory.
FS_Type: Description of the type of format of this storage media
accessory.
None.
None.
F S
ILE
336
C
YSTEM OMMANDS
44